33TIRES AND WHEELS
TIRES AND WHEELS
TIRES
To avoid personal injury:
A Do not attempt to mount a tire. This should be
done by a qualified person with the proper
equipment.
A Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A Inflation pressure in front tires rises quickly
when using compressed air.
Never operate machine with a loose rim, wheel, or
axle.
A Whenever bolts are loosened, retighten to
specified torque.
A Check all bolts frequently and keep them
tightened.
BInflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it everyday and inflate as necessary.
WHEELS
A When re-fitting a wheel, tighten the wheel bolt to the
following torques then recheck after traveling 200 m
(200 yards) changing directions several times.
Wheels with beveled or tapered holes:
Use the tapered wheel bolt.
Tire sizes
Recommended Inflation
Pressure
Front
15 x 6.0 - 6,
(Semi-pneumatic
Non Flat Tire) Rib
- - -
15 x 6.0 - 6,
4PR Rib
160 kPa
(1.6 kgf/cm , 23psi)
Rear
26 x 10.5 - 12,
4PR Turf
120 kPa
(1.2 kgf/cm , 17psi)
26 x 12.0 - 12,
4PR Turf
(1) Ground (A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
To Next Page
