- 23 -
In very dense and wet crops where it is necessary to reduce the forward speed, it
is essential that the revs of the tractor engine are maintained to allow the discs
and the conditioning rotor to turn at a speed necessary to operate correctly.
Never adjust, lubricate, clean or unclog machine while it is operating.
Stop tractor engine first.
NEVER MOW IN STONY OR ROCKY GROUNDS.
Check the tightness of all nuts and bolts 2 to 3 hours after the initial use of the
machine, in particular those securing the discs, knives and flails.
The interior of the machine must be cleaned at regular intervals,. Remove soil which
may have become stuck to the conditioning rotor (FC 202) or rollers (FC 202 R) or
to the cover. It is in your interest to keep the machine clean.
Always disconnect the primary PTO shaft when cleaning the conditioning unit.
Ensure that FC 202 R conditioning rollers or FC 202 free swinging fingers of the
conditioning rotor are always kept in good working order.
PARTS SUPPLIED WITH THE MACHINE
A box containing one set of standard replacement knives, a quantity of blade bolts,
nuts, one 8 mm allen key, one 10 mm alley key, a 18 mm box spanner (wrench) and a
set of four raised skids are supplied with the machine.
MAINTENANCE
To Next Page
