KUHN GMD24 - Page 6

GMD24-GMD28 / HD
6
2. - Contents
KN226BGB_A
Disc mower
9.6 Inner swath shield.......................................................................................................................... 56
9.7 Side deflector................................................................................................................................. 57
9.8 Side deflector with high cone disk ................................................................................................. 57
9.9 Frame connection arm/cutterbar.................................................................................................... 57
9.10 Lighting and signalling ................................................................................................................... 58
9.10.1 Electrical connection......................................................................................................... 58
9.11 Lateral signalling equipment (Only for France)..............................................................................58
9.12 Lighting and signalling (Only for USA)........................................................................................... 59
9.12.1 Electrical connection......................................................................................................... 59
9.13 Compensating spring..................................................................................................................... 59
9.14 Toolbox .......................................................................................................................................... 60
9.15 Wear skids..................................................................................................................................... 60
10. Maintenance and storage ............................................................................................61
10.1 Frequency chart............................................................................................................................. 61
10.2 Lubrication ..................................................................................................................................... 62
10.2.1 PTO shafts........................................................................................................................ 63
10.2.2 Draining ............................................................................................................................ 64
10.3 Maintenance .................................................................................................................................. 67
10.3.1 Belt tension....................................................................................................................... 67
10.3.2 Breather plug checking and cleaning ............................................................................... 69
10.3.3 Checking cutterbar oil level ..............................................................................................69
10.3.4 Inspection of knives and securing elements..................................................................... 70
10.3.5 Knife replacement............................................................................................................. 73
10.3.6 Disc replacement.............................................................................................................. 74
10.3.7 Outer and inner cones...................................................................................................... 75
10.4 Storage .......................................................................................................................................... 76
10.4.1 At the end of each season................................................................................................ 76
10.4.2 At the start of each season...............................................................................................76
10.4.3 Storage ............................................................................................................................. 77
10.5 Dismantling and scrapping of the machine....................................................................................77
11. Troubleshooting guide.................................................................................................78
12. Appendix .......................................................................................................................79
12.1 Calculating the load on an axle...................................................................................................... 79
13. Limited Warranty ..........................................................................................................87