KUHN GMD24 - 10.4 Storage; 10.4.1 At the end of each season; 10.4.2 At the start of each season

GMD24-GMD28 / HD
76
10. - Maintenance and storage
KN226BGB_A
Disc mower
10.4 Storage
10.4.1 At the end of each season
- Clean the machine thoroughly.
- Drain all gearboxes and cutterbar and refill with
new oil.
- Grease the cylinder rods in contact with the
outside.
- Grease the cylinder rods in contact with the
outside.
- Touch up any areas of damaged paintwork.
- Store the machine in a sheltered dry place with the
cutter bar in horizontal position.
- Inspect and replace worn knives and bolts.
- Slacken V-belts and check their condition.
- Fully lubricate the machine.
10.4.2 At the start of each season
- Check that all nuts and bolts are sufficiently
tightened.
- Check belt condition.
- Retension belts.
- Check that safety breakback system functions.
- Wipe off grease on cylinder rods.
- Re-read the operators' manual.
- Make sure that all protection devices are in place
and in good condition.
A7300019 0