Kurzweil Mark Pro 2i - Side Panel and Pedal Assembly

Mark Pro TWOi
12
Assembling the Stand
* Be careful when placing the Main set in the stand. Do not push down or pull forward
the Main set without tightening all the screws on the stand.
Side Panel and Pedal Assembly
Figure 2-2 Mark PRO 2i Side panel and Pedal Assembly
1. Place pedal box 4 on the left side panel 2 and fasten the screw 10 on the hole.
2. Put on the right side panel 3 in the same way.
3. Take out the pedal cable from inside of the pedal box 4.