Kurzweil Mark Pro 2i - Removing Internal Boards

Mark Pro TWOi
18
Bottom Surface
Figure 2-6 Mark PRO 2i Bottom surface
The Mark Pro2i has two 1/4” headphone jackes on the surface of the keyboard so that two can
listen and play at the same time. The volume for both jacks is controlled identically by the main
volume knob located at the far left side on the front panel.
Removing the Scanner Board
1. Follow the procedure described to remove the top panel Assy.
2
. Following Steps 3–5, disconnect the cables listed in Table 2-2
Ref. Name Cable Type Destination
J6 MIDI/CPU standard wire Engine Board
J
4
F
ront
P
anel
flat
r
i
b
bon
F
ront
P
anel Board
J
2
T
re
b
le
flat
r
i
b
bon
K
e
yboard Assem
b
ly
J
3
Bass
flat
r
i
b
bon
K
e
yboard Assem
b
ly
J
1
2
Engine I/O
S
tandard wire
Amp Board
J9 Piano Pedals Standard wire Pedals
Table 2-2 Connector Board cables