Mark Pro TWOi
26
Entering Diagnostics
Apply power to the unit. Press Global button one time while three dots blinking in the 7-
segment. After a while, segment display the following message.
Figure 3-1 7 segment example, entering diagnostics
Press either the +/Yes or -/No until . Appears in the segment.
And Press the Transpose + button for enter into menu item display the following.
Figure 3-2 7 segment example, entering diagnostics
Press Transpose + button to select the run one test mode. To select the run burn-in
test mode, press either the +/Yes or -/No button then press the Transpose + button to
begin the tests.
To Next Page
Loading...
