Mark Pro TWOi
35
Installing a New Boot Block
Warning: This procedure performs a hard reset. All user programs and setups will be erased.
Before continuing, be sure to save all user programs and setups.
1. Connect a MIDI cable from the MIDI Out port of the computer interface or sequencer to
the MIDI In port on the Mark Pro 2i.
2. Using the sequencer program, open the
fi
rst .MIDI
fi
le.
3. Turn on the Mark Pro 2i and follow the procedure to enter the Boot Block.
4. Press the Enter button to select .
6. The segment shows . Start playing the MIDI
fi
le from the sequencer.
While a
fi
le is loading, the bottom line of the display shows the progress. If the display
continues to show
after starting the sequencer, stop and restart the
sequence.
7. After the file is loaded, the unit will reset.
Replacing the Battery
The Mark Pro 2i uses a
fl
at three volt Lithium coincell battery. When the battery voltage runs
low, the unit boots up with a low battery message.
Note: The battery voltage can be checked at anytime using the Scanner Diagnostics.
To Next Page
Loading...
