Mark Pro TWOi
36
Accessing the Battery
1. Place the Mark Pro 2i upside down on a
fl
at protected surface.
2. Remove top assembly and set it safely aside.
Removing the Battery
The battery (CR2032) in the Mark Pro 2i is mounted into a holder on the Engine Board and is
accessible when the access panel is removed.
1. Insert a
fl
at plastic tool (plastic knife, pen cap, etc.) into one of the openings between the
battery and the holder to lift the battery.
Figure 4-1 Battery and Holder
2. Ease the battery out of the holder. If necessary, insert the plastic tool at the bottom of the
holder (closest to the Engine Board) to remove the battery.
Installing the Battery
1. Position the battery over the holder so that the positive terminal is pointing to the Engine
Board.
2. Slide the battery into the holder and apply slight pressure until it snaps into place.
3. Install the seven screws to secure the top assembly.
To Next Page
Loading...
