Mark Pro TWOi
34
Installing the Operating System or Setups
Warning: This procedure requires performing a hard reset. All user programs and setups will be
erased. Before continuing, be sure to save all user programs and setups.
1. Connect a MIDI cable from the MIDI Out port of the computer interface or sequencer to
the MIDI In port on the Mark pro 2i.
2. Open the first .MID file using the sequencer program.
3. Turn on the Mark Pro 2i and follow the procedure to enter the Boot Block.
4. Press the Enter button to select “uOS”
5. The segment shows “uOS”. Start playing the MIDI file from the sequencer.
While a
fi
le is loading, the bottom line of the display shows the progress. If the
display continues to show after starting the sequencer, stop and restart the sequence.
6. After the
fi
le is loaded, the display will show “oK”.
7. If you have additional
fi
les to load, open the
fi
le from the sequencer and begin playing it.
8. Press the Cancel button twice to return to the main menu. Scroll to Hard Reset and select.
To Next Page
Loading...
