Kurzweil Mark Pro 2i - Page 16

Mark Pro TWOi
14
1. Place the Main set on the stand so that the wood pegs on the top of the side
panel fit into the holes on the bottom surface of the keyboard.
2. Attach the side panels to the Main set with the metal brackets. Use the bolt 12
for the front hole, and 9 for the rear.
3. Insert the pedal cable connector to the jack on the bottom surface of the Main
set as shown in the left figure.
4. Locate the unit to the desired place and rotate the height adjustment screw until
it supports the pedal box, preventing the pedal box from bending when you
press the pedals.
Be sure to install the adjustment screw and perform the adjustment procedure
before depressing the pedals. Failure to do so may result in damage to the pedal
box.
5. Attach the headphone hanger wherever you wish.
Figure 2-5 Mark PRO 2i Headphone hanger