Layering
25
Selecting a Voice
To create a layered voice, press the
[Layer] button to enter Layer Mode.
The [Layer] button is located on the
left side of the front panel.
When the [Layer] button is pressed, the current voice becomes the primary layer voice.
Select the voice you want to use as your primary voice. Then press the [Layer] button to enter
Layer mode. The [Layer] button LED lights and PRG:87 scrolls across the display. This is the
secondary voice of the layer. (The default voice is 87, LA Strings.)
The primary voice is now layered with the secondary voice.
Using the parameters available in Layer Mode, you can modify the layered voices. The first
parameter, Layer Voice, is active when you press the [Layer] button. Descriptions of the Layer
Mode parameters follow.
To exit Layer Mode, press the [Layer] button.
Layer Mode Parameters
There are three parameters available in Layer Mode. Changing the value of a parameter
determines the performance of the layer.
In Layer Mode, use the [Select] and buttons to step through the parameters. To change
the value of parameter, press the [Prev] or [Next] button.
NOTE: Changes to the Layer Voice, Layer Volume and
Layer Transposition are remembered for the next time you
layer; but are not stored in memory. They return to their
default settings when you turn off the MPS20. Be sure to
save your changes as one of the Favorites!
To Next Page
Loading...
Need help?
General
