26
Layering
Chapter 6
Layering
Layer Voice
This parameter is for the secondary voice. When you press the [Layer] button, this parameter is
active and the secondary voice ID number, PRG:87, (87, the default voice) scrolls across the
display. To choose a different voice as the secondary voice, select a category and use the [Prev]
or [Next] button to step through the list of voices.
Default Setting: PRG:87, LA Strings
Range: Any available voice
Reset: [Value Jump] button pair resets to the default voice
Layer Volume
This parameter sets the volume between the layered voices. When you select the Layer Volume
parameter, the display scrolls VOL:0 (0 is the default setting). The value range of this parameter
is +/-0–9. Use the [Prev]# button to decrease the volume of the secondary voice or the [Next]
button to increase its volume.
Default Setting: 0
Range: +/-0–9
Reset: [Value Jump] button pair
Layer Transposition
This parameter sets the transposition of the secondary voice relative to the primary voice. You
can transpose the secondary voice up or down one or two octaves from the primary voice. When
you select this parameter the display scrolls XPOSE:0 ST. Use the [Prev] or [Next] button
to transpose the secondary voice.
Default Setting: 0 ST
Range: -24 ST, -12 ST, 0 ST, 12 ST, 24 ST
Reset: [Value Jump] button pair
To Next Page
Loading...