Kurzweil PC361 User Manual

3-26
Setup Mode
Riffs
Duration (Dur)
DurationchangesthedurationofeachMIDInote.Theoriginaldurationsofthenotesinthe
sequencearemultipliedbytheselectedpercentage.100%willcausenochange,valuessmaller
than100%willresultinshorterdurations,valueslargerthan100%willresultinlonger
durations.
Velocity
Velocitychangesthevelocity
ofeachMIDInote.Theoriginalvelocitiesofthenotesinthe
sequencearemultipliedbytheselectedpercentage.100%willcausenochange,valuessmaller
than100%willresultinlowervelocities,valueslargerthan 100%willresultinhighervelocities.
Offset
Youcanfinetunethestarttimeofyour
riffinticksbyusingtheOffsetparameter.Apositive
valuewilldelaythestarttime,whileanegativevaluewillspeedupthestarttime.
Real-time Control of Riff Parameters
Youcanhavereal‐timecontroloverseveralRiffparameters,byassigningphysicalcontrollersto
specialRiffControllerDestinations.Anyinput(orentryvalue)fromaphysicalcontroller
assignedtoaRiffControllerDestinationoverridestheprogrammedvaluesfortheparametersof
theriffonthatcontroller’szone.Theoverrideremains
ineffectuntilyouselectadifferentsetup.
Remember,eachofthefollowingControllerDestinationsaffectsonlytheriffforthezonewhich
yourcontrollerisassignedto.
Controller
Number
Corresponding
Riff Parameter
Operation
163 RiffOn Riff On. Any value triggers the zone’s Riff if Riff is set to On
on RIFF1 page.
164 RiffOff Riff Off. Any value stops playback of zone’s Riff.
165 RiffDur Riff Duration, sets the Duration parameter (see above.) The
Duration value is calculated by multiplying the received
controller value by 1000, and dividing the answer by 128 (any
decimal points are taken off the final value.) Here are some
example values: 7 = 54%, 13 = 101%,19 = 148%, 32 = 250%,
64 = 500%, 127 = 992%
166 RiffVel Riff Velocity, sets the Velocity parameter (see above.) The
Velocity value is calculated by multiplying the received
controller value by 2. For Example, 25 = 50%, 50 = 100%,
100 = 200%, 127 = 254%.
167 RiffDly Riff Delay, Controls Offset parameter (see above.) Controller
value 64 = 0 offset ticks. Each value away from 64 = 512
offset ticks. For example, 63 = -512 offset ticks, 65 = +512
offset ticks, 0 = -32768 offset ticks, 127 = +32256 offset ticks.

Kurzweil PC361 Specifications

General

Brand	Kurzweil
Model	PC361
Category	Synthesizer
Language	English