©2015 Spectrum Brands, Inc.
Troubleshooting: Installation
If you encounter any of the problems above, the deadbolt latch may be
installed upside down. Remove the interior assembly, mounting plate,
and exterior assembly from the door, and look at the latch inside the
door hole.
If the word “UP” is upside down and at the bottom of the latch, the latch
is installed incorrectly.
Reinstall the latch, making sure the word “UP” faces upward.
©2015 Spectrum Brands, Inc.
61883 / 01
8 / 17
Technical Support
1-866-863-6584
www.kwikset.com
2
A
B
C
The interior mounting screws are di cult to tighten.
The interior and exterior assembly won’t mount parallel to the door edge.
The interior assembly does not fi t on the mounting plate.
To Next Page
Loading...
