13. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
13-8
Inspect the driven sprocket.
Replace sprocket if more than 1/4 teeth
wear or bent teeth.
Replace it if the brake disk is cracks or
damage.
Replace it if splines of the brake disk is
wear or damage.
Inspect rear axle hub.
Replace it if bearing allow play in the axle
hub or the bearing turns roughly.
Replace it if oil seal is wear or damage.
Replace it if rear axle hub is cracks, bend or
damage.
Bearing and oil seal replacement steps:
Clean the outside of the rear axle.
Remove the oil seal by a flat-head screw
driver.
Remove the bearing by a general bearing
puller.
Install the new bearings and oil seal by
reversing the previous steps.
Brake Drum Cove
Splines
Oil Seal
Place a wood block against the outer
edge to protect this edge.
＊
Do not strike the center race or balls of
the bearing.
Contact should be made only with the
outer race.
＊
Distance Colla
To Next Page
Loading...
Need help?
General
