KYMCO Mongoose 50-4T

13. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
13-9
INSTALLATION
Reverse the “REMOVAL” procedures.
Install the rear axle hub.
Install the rear axle.
Install brake disk, driven sprocket and
collars.
Install wheel hub (see page 13-5) and rear
wheel (see page 13-4).
Adjust drive chain slack. (Refer to the
“DRIVE CHAIN SLACK ADJUSTMENT”
section in chapter 3.)
Approximately: 10~20 mm (0.4~0.8 in)
At this time, the rear axle hub should not
be tightened completely.
Final tightening is done after the chain
slack ad
j
ustment.
＊
Apply grease onto the oil seal lips,
bearings and bushes.
＊
The left wheel hub nut should be
tightened first then right wheel hub nut
should be tightened when the rear axle is
installed.
＊