1234567 = Shipment
1/1 = Package x of y
n
TO AHN to address
ntax in PRESCRIBE
To control the MaxiCode from PRESCRIBE, the commands XBCP and
XBAR are used.
he content of the useful data, i.e. the primary and secondary
information, are described above in the syntax for controlling with PCL. They
app
me
eset and selection of MaxiCode. This command must appear before
each MaxiCode request issued from PRESCRIBE.
stands for the MaxiCode mode; in the Barcode Flash solution, modes 2
through 6 are available.
or Structured Append mode: within a group of symbols, the sequential
number of the symbol currently to be printed must be entered here. In the
abs
or Structured Append mode: the total number of symbols in the group of
symbols currently to be printed must be entered here. In the absence of this
parameter, the Barcode Flash solution assumes only one symbol as standard.
10 = Package weight
Y = Address validatio
OT -H -STRASSE 12= Ship
MEERBUSCH= Ship to city
DE = Ship to state
Sy
The rules for t
ly likewise in the case of a request issued from PRESCRIBE, with the
difference that the primary information is formed with XBCP while the
secondary information lies in the useful data. For the example below the sa
data are used as in the previous PCL example.
XBCP 0,8;
R
XBCP 1,#;
#
XBCP 2,#;
F
ence of this parameter, 1 is used as standard.
XBCP 3,#;
F
51
To Next Page
Loading...
