Name: Kyocera ECOSYS FS-C8520MFP
Brand: Kyocera
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Chapter 2 Graphics Tutorial

2-6

Figure 2. 4. Result of Draw Commands: Lines in Angles

The first two lines of this command sequence initiates the PRESCRIBE mode, resets

printing system defaults to permanent settings, and sets the line width to 0.01 inches.

Then the MZP command on line 3 moves the cursor to a point 5 inches to the right of the

left edge limit and 4 inches below the top edge limit.

Next, DRPA 2, 149; on line 4 draws a line two inches long at an angle of 149 degrees.

The angle is measured clockwise from the vertical axis. The subsequent DRPA com-

mands draw additional 2-inch lines at angles that increase in increments of 72 degrees.

As indicated by the CMNT (CoMmeNT) commands, angles that exceed 360 degrees are

equivalent to the remainder of division of the angle by 360.

Drawing Boxes and Circles

PRESCRIBE provides two commands especially for drawing boxes (BOX command)

and circles (CIR command).

Drawing Boxes

The BOX (draw box) command draws a box of a specified width and height. As with the

line drawing commands, the thickness of the line used to draw the box is determined by

the SPD (set pen diameter) command.

The following command sequence draws a box.

!R! RES;

UNIT C;

SPD 0.1;

MZP 3, 3;

BOX 3, 4;

PAGE;

EXIT;

Other manuals for Kyocera ECOSYS FS-C8520MFP

Questions and Answers:

Need help?

Do you have a question about the Kyocera ECOSYS FS-C8520MFP and is the answer not in the manual?

General