Kyocera ECOSYS M2040dn/KL3 User Manual

10-29
Troubleshooting > Troubleshooting
2102
2103
Failed to send via FTP. Check the network.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
—
Check the following of the FTP server.
• Is FTP available?
• The server is not operating properly.
—
Failed to send the e-mail. Check the network.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
—
2201
2202
2203
2231
Failed to send the e-mail.
Failed to send via FTP.
Failed to send via SMB.
Check the network.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
—
2204 Failed to send the e-mail. Check the e-mail size limit of the SMTP settings on
the Command Center RX.
page 2-51
3101 Failed to send the e-mail. Check the authentication methods of both the sender
and the recipient.
—
Failed to send via FTP. Check the network.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
—
3201 Failed to send the e-mail. Check the SMTP user authentication method of the
recipient.
—
0007
4201
4701
5101
5102
5103
5104
7101
7102
7103
720f
— Turn the power switch off and back on. If this error
occurs several times, make a note of the displayed
error code and contact your service representative.
page 2-10
9181 — The scanned original exceeds the acceptable number
of pages of 999. Send the excess pages separately.
—
Error
Code
Message Corrective Actions
Reference
Page

Kyocera ECOSYS M2040dn/KL3 Specifications

General

Brand	Kyocera
Model	ECOSYS M2040dn/KL3
Category	All in One Printer
Language	English