Kyocera ECOSYS M3540idn

8-29
Setup and Registration (System Menu) > System Menu
Item Description
Protocol Detail ―
NetBEUI Selects whether or not to receive documents using NetBEUI.
*1
Value: Off, On
*1 The setting will be changed after restarting the device or the network for the machine.
LPD Select whether or not to receive documents using LPD as the network protocol.
*1
Value: Off, On
SMTP (E-mail TX) Select whether or not to send e-mail using SMTP.
Value: Off, On
POP3 (E-mail RX) Select whether or not to receive e-mail using POP3.
Value: Off, On
FTP Client
(Transmission)
Select whether or not to send documents using FTP. When selecting [On], set the FTP Port
Number. Use the FTP default port 21.
Value: Off, On, Port 1 - 65535
FTP Server (Reception) Select whether or not to receive documents using FTP.
*1
Value: Off, On
SMB Client
(Transmission)
Select whether or not to send documents using SMB. When selecting [On], set the SMB default
Port Number. Use the SMB default port 445.
Value: Off, On, Port 1 - 65535
LDAP Select whether or not to use LDAP.
Value: Off, On
SNMP Select whether or not to communicate using SNMP.
*1
Value: Off, On
SNMPv3 Select whether or not to communicate using SNMPv3.
*1
Value: Off, On
HTTP Select whether or not to communicate using HTTP.
*1
Value: Off, On
HTTPS Select whether or not to communicate using HTTPS.
*1 *2
Value: Off, On
*2 Set "SSL" to [On] in Secure Protocol
on page 8-31.
IPP Select whether or not to communicate using IPP. When selecting [On], set the IPP default Port
Number. Use the IPP default port 631.
*1 *2
Value: Off, On, Port 1 - 32767
IPP over SSL Select whether or not to use IPP over SSL. When selecting [On], set the IPP over SSL default
Port Number. Use the IPP over SSL default port 443.
*1 *2
Value: Off, On, Port:1 - 32767
Raw Port Select whether or not to receive documents using Raw Port.
*1
Value: Off, On