2JN-2
1-3-16
U053
Setting the adjustment of the motor speed
Description
Performs fine adjustment of the speeds of the motor.
Purpose
To adjust the speed of the motor when the magnification in the auxiliary scanning direction is not correct.
Method
1. Press the start key.
Adjustment
1. Press the system menu/counter key.
2. Press the start key to output a VTC pattern.
Figure 1-3-4
3. Press the system menu/counter key.
4. Change the setting value using the cursor left/right keys or numeric keys.
Increasing the setting makes the image longer in the auxiliary scanning direction, and decreasing it
makes the image shorter in the auxiliary scanning direction.
5. Press the start key. The value is set.
6. Turn the main power switch off and on.
Maintenance
item No.
Description
Display Description Setting
range
Initial
setting
Change in
value per step
MAIN MOTOR Main motor speed adjustment -50 to 50 0 0.5%
100
150
200
250
To Next Page
Loading...
