Kyocera FS-1128MFP - Page 56

2JN
1-3-28
U089
Outputting a MIP-PG pattern
Description
Selects and outputs the MIP-PG pattern created in the machine.
Purpose
To check copier status other than scanner when adjusting image printing, using MIP-PG pattern output (with-
out scanning).
Method
1. Press the start key.
2. Select the MIP-PG pattern to be output using the cursor up/down keys.
Method: Gray Scale
1. Select [Gray Scale] using the cursor up/down keys and press the start key.
2. Select [HTFM1], [HTFM2], [Dither1] or [Dither2] using the cursor up/down keys and press the start key.
3. Select [ON] or [OFF] using the cursor up/down keys and press the start key.
4. Press the system menu/counter key.
5. Press the start key. A MIP-PG pattern is output.
6. To return to the screen for selecting an item, press the system menu/counter key.
Method: Mono-Level
1. Select [Mono-Level] using the cursor up/down keys and press the start key.
2. Change the value using the cursor left/right keys or numeric keys and press the start key.
3. Select [HTFM1], [HTFM2], [Dither1] or [Dither2] using the cursor up/down keys and press the start key.
4. Select [ON] or [OFF] using the cursor up/down keys and press the start key.
5. Press the system menu/counter key.
6. Press the start key. A MIP-PG pattern is output.
7. To return to the screen for selecting an item, press the system menu/counter key.
Maintenance
item No.
Description
Display PG pattern to be output Purpose
Gray Scale To check the laser scanner unit
engine output characteristics.
Mono-Level To check the drum quality.
256-Level To check resolution
reproducibility in printing.
1 dot-Level To check fine line reproducibility.
To adjust the position of the laser
scanner unit (lateral squareness)
Description Setting range Initial setting
Gray level 0 to 255 0