4-15. Management/E-mail > SNMP > General
The SNMP protocol is used to transfer administrative information across a network. You can choose between SNMPv1/v2c or SNMPv3.
Filter Setting You can designate strings to filter messages (up to 255 characters). Create filter strings using the
following prefixes.
— S: Filter by Subject
— T: Filter by To
— C: Filter by Cc
— F: Filter by From
To filter by any of several conditions (OR), separate strings with "|". To filter by several conditions
(AND), all of which must be met, separate strings with "&". For example, to print only messages
with a subject of "Service" or "Technical", use "S:Service | S:Technical".
Cover Page When you have set up printing from e-mail, designate whether or not to print the message body as
well. Choose On to add a cover page when printing messages. If there is text in the message
body, it will be printed as the cover page. Choose Off to print file attachments only. If there is no
file attachment, nothing is printed.
POP over SSL Allows the SSL encryption for mail sever communication. Select OFF when it is not used.
— OFF
— StartTLS
— POP over SSL
— To activate the configuration, the Encryption needs to be set to ON.
Utilities that use a management information base (MIB) may not operate if SNMPv3 is turned on. In this situation, turn SNMPv3
off and set SNMPv1/v2c to Onor Read Only.
Item Description
SNMPv3 Enables (On) or disables (Off) SNMPv3. The SNMPv3 protocol provides security using DES
encryption and MD5/SHA authentication. When SNMPv3 is on, set SNMPv1/v2c to Read Only or
Off.
User Name Enter the username used by SNMPv3. Maximum of 32 single-byte characters.
Authentication Protocol You can choose between MD5 and SHA1.
Encryption Select the encryption algorithm from the following choices. Select OFF when it is not used.
— OFF
— DES
— AES
— To activate the configuration, the Encryptio
needs to be set to ON.
Authentication Password Enter the password for authentication. Maximum of 40 single-byte characters.
Privacy Password Enter the password for encryption. Maximum of 32 single-byte characters.
SNMPv1/v2c SNMPv1/v2c can be set to enabled (On), Read Only, or disabled (Off). Turn SNMPv3 off if this
setting is set to On.
Read Community This is used to read device information. The default read community string is public. The correct
read community needs to be entered for an administration utility to send an SNMP request to read
a value, otherwise the IB-51 will reject the request.
Page 1
of 2
Using a Web Browser to Manage the I
-51
10
2
201
file:///C:/Tom/PDF/I
-51/I
-51%20Setu
%20Guide%20HTML%20En
lish/card
home
...
To Next Page
Loading...
Need help?
General
