2K3/2L3
2-2-4
(2) Switches and sensors
Figure 2-2-2 Switches and sensors
1. Home position sensor (HPS) ................ Detects the ISU in the home position.
2. Original detection switch (ODSW) ........ Operates the original size detection sensor.
3. Original size sensor (OSS) ................... Detects the size of the original.
4. Front cover switch (FCSW)................... Detects the opening and closing of the front cover.
5. Right cover switch (RCSW) .................. Detects the opening and closing of the right cover.
6. Feed sensor (FS) .................................. Detects a paper misfeed in the vertical conveying section.
7. MP paper sensor (MPPS) ..................... Detects the presence of paper on the MP tray.
8. Registration sensor (RS)....................... Controls the secondary paper feed start timing.
9. Duplex sensor (DUS) ............................ Detects a paper jam in the duplex section.
10. Eject sensor (ES) .................................. Detects a paper misfeed in the fuser or eject section.
11. Paper full sensor (PFS)......................... Detects the paper full in the inner tray.
12. Job paper full sensor (JPFS) ................ Detects the paper full in the job separator tray.
13. Paper sensor 1 (PS1) ........................... Detects the presence of paper in the cassette.
14. Paper sensor 2 (PS2) ........................... Detects the presence of paper in the cassette.
15. Lift sensor (LS)...................................... Detects activation of upper limit of the bottom plate.
16. Paper size width switch (PWSW).......... Detects the width of paper in the cassette.
17. Paper size length switch (PLSW) ......... Detects the length of paper in the cassette.
18. Toner container lock sensor (TCLS) ..... Detects the lock of toner in the toner container.
Machine innerMachine front Machine rear
1
2
3
13
24
12
23
5
10
9
7
16
6
8
19
15
14
26
21
18
22
4
20
25
11
28
17
To Next Page
Loading...
