3-3
Methods For Entering the Destination > Entering the destination fax number with the numeric keys
4
Press [OK].
Entry of the destination finishes.
Key Description
On Hook Press [On Hook] to connect to the telephone line.
When the FAX number has been entered, the machine starts
dialing to the receiving system.
After pressing this key, you can dial the number of the
receiving system using the numeric keys. For details, refer to
Manual Send on page 4-16.
Sub Address To communicate using the sub address, press this key. For
details, refer to Sub Address Transmission on page 6-23.
Detail Settings TX Start Speed To change the transmission start speed, press this key. Select
the speed from 33,600 bps, 14,400 bps, and 9,600 bps.
NOTE
Normally this should be used with the default setting.
ECM ECM is a communication mode specified by the ITU-T
(International Telecommunication Union) that retransmits data
when an error occurs. Fax machines that have ECM mode
check for errors as they communicate, preventing distortion of
the image due to noise on the line and other conditions.
Encrypted
Transmission
To send faxes using encryption, press this key. For details,
refer to Encryption on page 6-36.
NOTE
When On is selected in Entry Check for New Dest., a confirmation screen is displayed for
the entered FAX number. Re-enter the same FAX number and press [OK]. For details, refer
to Entry Check for New Dest. in the Operation Guide for the machine.
Press [Next Dest.] to enter the next fax number.
For details, refer to
Broadcast Transmission on page 3-8.
In addition to a fax, you can include e-mail transmission and folder (SMB/FTP) transmission
to send as one job. For details, refer to the machine’s Operation Guide.
FAX
10:10
On Hook
Cancel
Sub Address
Pause Space Backspace
Detail Settings
OKMenu Next Dest.
1234567890
Ready to send.
GB0703_00
To Next Page
Loading...
