2-52 Using the Operation Panel
RA(Stateless) (RA (Stateless) setting)
The IPv6 router communicates (transmits) information such as the global
address prefix using ICMPv6. This information is the Router
Advertisement (RA).
ICMPv6 stands for Internet Control Message Protocol, and is a IPv6
standard defined in the RFC 2463 "Internet Control Message Protocol
(ICMPv6) for the Internet Protocol Version 6 (IPv6) Specification".
1 Press Z while >TCP/IP (IPv6) On > is displayed.
2 Press U or V repeatedly until >>RA(Stateless) appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using U or V.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
DHCPv6 (DHCPv6 setting)
DHCPv6 is the next-generation of the Internet's Dynamic Host
Configuration Protocol and supports IPv6. It extends the BOOTP startup
protocol that defines the protocols used for transferring configuration
information to hosts on the network.
DHCPv6 permits the DHCP server to use its expanded functionality to
send configuration parameters to an IPv6 node. Because the network
addresses that can be used are allocated automatically, the IPv6 node
management workload is reduced in systems where the administrator
has to exercise close control over IP address allocation.
1 Press Z while >TCP/IP (IPv6) On > is displayed.
2 Press U or V repeatedly until >>DHCPv6 appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using U or V.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
To Next Page
Loading...
Need help?
General