5.3 Cleaning the Printer
5-8
3
33
3
First we clean main charger wire. Grasp the tab of the
cleaning knob (green-colored). Gently pull the
cleaning bar out and push it back in. Repeat this 3 to 5
times.
Figure 5-17
4
44
4
Next, we clean main charger grid. Take the grid
cleaner out of the toner kit. Take the grid cleaner out
of the protectilve bag and remove the cap.
Figure 5-18
Note
The pad of the grid cleaner contains
water. Clean the grid quickly so that the
pad may not dry off.
5
55
5
Attach the grid cleaner to the printer with the pad
facing up.
Figure 5-19
6
66
6
While slightly raising the charger unit, slowly pull it
out and push it back in two or three times. This cleans
the grid on the bottom of the charger unit.
Figure 5-20
7
77
7
After cleaning is finished, remove the grid cleaner
from the printer and discard it. The grid cleaner
cannot be reused.
Cleaning
knob
Cap
Grid cleaner
Grid cleaner
Main charger
unit
To Next Page
Loading...
