2.3 Loading Paper
2-8
2.3.2 Loading paper into the MP
(Multi-Purpose) tray
Perform the following procedure to load paper into the MP
tray.
1
11
1
Open the MP tray located on the right side of the
printer.
Adjust the length of the tray according to the side of
paper you will use.
Figure 2-7
2
22
2
Adjust the position of the paper guides according to
the size of the paper you will use.
Figure 2-8
3
33
3
Square the edges of the paper and then carefully place
it onto the MP tray.
Figure 2-9
4
44
4
Set the MP tray paper size on the printer’s operator
panel. Refer to Chapter 3 Using the Operator Panel,
section 3.10.2 Setting MP Tray Paper Size on page
3-48.
To close the MP tray, remove all of the paper from it,
slide the paper guides as far apart as they will go, and
then close the tray.
Figure 2-10
MP Tray
Paper Guide
Paper Guide
To Next Page
Loading...
