1.2 Parts and Functions
1-8
1.2.3 Rear
Figure 1-4
1Vents
Vents allow cooling air to enter and ozone to exit.
2 Memory Card Slot
This slot receives a memory (Compact Flash) card. A memory card can hold fonts,
macros, forms, etc., that can be downloaded in the printer’s memory. For details, see
Appendix A Options, section A.3.1 Memory Card on page A-5.
3 Network Indicators
These indicators light according to the communication status with the network.
10BASE-T indicator (10): Lights when you are connected to the network at 10 Mbps.
100BASE-TX indicator (100): Lights when you are connected to network at 100 Mbps.
Status indicator (ST): Flashes during data communication.
4 Network Interface Connector
Connects to the network via a 10BASE-T/100BASE-TX network cable.
5 Parallel Interface Connector
This connector is for a standard Centronics parallel interface cable from the computer.
Connect this connector to the computer’s parallel port.
6 Option Interface Card Slot (Network) [OPT2]
This slot holds an optional network interface card for network printing. (An optional
Hard disk can’t be used in this slot.) For details see Appendix A Options.
7 Hard Disk Slot (OPT1/HDD)
This slot holds an optional hard disk (HD-10) for storing print jobs. A Kyocera Mita
manufactured hard disk must be used. For details, see Appendix A Options, section
A.3.7 Hard Disk on page A-7.
1
2
65
3
4
7
To Next Page
Loading...
