Kyocera KM-3060

2H0/2HZ-1
1-5-60
4. Remove four screws and remove the HDD
mount.
5. Replace the hard disk and Install the hard
disk.
6. Refit all the removed parts.
7. When the hard disk is replaced, perform
maintenance mode U024 to initialize the
hard disk (see page 1-3-17).
When the fax backup kit is installed, perform the
following procedures (see page 1-3-79 ).
1. Run maintenance item U933 and press
[FAX IMAGE] to print out the FAX image.
2. Run maintenance item U933 and press
[JOB ACCOUNTING] to restore the job
accounting data to the hard disk.
3. Run maintenance item U933 and press
[INITIALIZE CF] to initialize the fax backup
kit.
Figure 1-5-108
Screw
Screw
Screw
Screw
HDD mount
Hard disk