2FB/2FC
1-4-65
U506
Setting the time out
Description
Sets the communication timeout time for connection to a computer.
Purpose
To change the preset value if a communication error occurs after connection to a computer continues for a
long time. By delaying the error detection timing, the error may be cleared. If the error is not cleared after the
preset value is changed, however, return the preset value to the initial value.
Method
Press the start key. The current setting is displayed.
Setting
1. Change the value using the cursor up/down keys.
The setting can be changed by 10 s per step.
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key.
The screen for selecting a maintenance item No. is displayed.
U508
Setting the LDAP
Description
Enables or disables an LDAP server.
Purpose
To change the setting to ON when use of an LDAP server is requested.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select ON or OFF. The selected item is displayed in reverse.
Initial setting: OFF
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key.
The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Description Setting range Default setting
Timeout time 10 to 120 (s) 10
Display Description
ON LDAP server is enabled.
OFF LDAP server is disabled.
To Next Page
Loading...
