2FB/2FC-3
1-4-73
U935
Relay board maintenance
Description
Sets the machine status temporarily when call for service (C0060 and C0330) occurs. However, after the set-
ting, call for service (C0060 and C0330) occurs again when progress of period.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select the item to be set. The selected item is displayed in reverse.
Initial setting: MODE 0
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key.
The screen for selecting a maintenance item No. is displayed.
Supplement
After removing the cause of the problem, be sure to change the setting in OFF.
U954
Setting the type of cooling fan
Description
Sets the new or old type of cooling fan.
Purpose
To change the setting according to the type of the cooling fan.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select MODE1 or MODE2. The selected item is displayed in reverse.
Initial setting: MODE2*
1
/MODE1*
2
*1: For the machine produced in July, 2005 and after.
*2: 120 V specifications only (for the machine produced in before June, 2005).
2. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
MODE 0 Setting mode: OFF
MODE 1 Setting mode: 60 cpm machine status
MODE 2 Setting mode: 80 cpm machine status
Display Description
MODE2 New type of cooling fan
MODE1 Old type of cooling fan
To Next Page
Loading...
