Kyocera KM-6030 - Page 206

2FB/2FC-4
1-5-45
C8310 Document finisher* centerfold unit
side registration guide problem
• During initialization, the front/rear side
registration guides are not detected in
the home position within 600 ms after
the guide returns to the home position.
• When the side registration guide is
operated from the home position, the
side registration guide home position
sensor does not turn off within 100 ms.
Loose connection
of the side registra-
tion guide motor
connector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
remedy or replace the cable.
Malfunction of the
side registration
guide motor.
Replace the side registration guide motor
and check for correct operation.
Malfunction of the
side registration
guide home posi-
tion sensor.
Replace the side registration guide home
position sensor and check for correct opera-
tion.
Loose connection
of the side registra-
tion guide home
position sensor
connector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
remedy or replace the cable.
Defective center-
fold unit main
PWB.
Replace the centerfold unit main PWB and
check for correct operation.
C8320 Document finisher* centerfold unit
centering plate problem
• During initialization, the centering plate
is not detected in the home position
when the centering plate returns to the
home position.
Loose connection
of the centering
plate motor con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
remedy or replace the cable.
Malfunction of the
centering plate
motor.
Replace the centering plate motor and
check for correct operation.
Malfunction of the
centering plate
home position sen-
sor.
Replace the centering plate home position
sensor and check for correct operation.
Loose connection
of the centering
plate home posi-
tion sensor con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
remedy or replace the cable.
Defective center-
fold unit main
PWB.
Replace the centerfold unit main PWB and
check for correct operation.
Code Contents
Remarks
Causes Check procedures/corrective measures