Kyocera KM-6030 - Page 447

2FB/2FC-2.0
2-4-9
Section
Maintenance
part/location
Method Maintenance cycle Points and cautions Page
Developing
section
Developing unit Replace Every service
P.1-6-60
Section
Maintenance
part/location
Method Maintenance cycle Points and cautions Page
Transfer
section
Transfer belt Replace Every service P.1-6-63
Transfer roller Replace Every service P.1-6-65
Idle belt roller Clean Every service Clean with a wet cloth and
then a dry cloth.
Transfer belt roller Clean Every service Clean with a wet cloth and
then a dry cloth.
Transfer ground roller Clean Every service Clean with a wet cloth and
then a dry cloth.
Check the continuity
between roller and ground
screw.
Transfer rear guide film Clean Every service Clean with alcohol or a dry cloth.
Transfer rear brush Clean Every service Clean with alcohol or a dry cloth.
Section
Maintenance
part/location
Method Maintenance cycle Points and cautions Page
Cleaning
section
Cleaning unit Replace Every service
P.1-6-66
Cleaning lamp Clean Every service Clean with a dry cloth.
Section
Maintenance
part/location
Method
Maintenance cycle Points and cautions Page
Charge eras-
ing section
PTC unit Clean
Check and
replace
Every service Clean the shield with a wet
cloth and then a dry cloth.
P.1-6-68
PTC cleaning pad Replace Every service P.1-6-68
PTC wire Replace Every service P.1-6-69