2FB/2FC-4
1-3-16
3. As shown in the figure, affix the sponge to
the top cover of the finisher after wiping the
cover with alcohol.
Aligning the bottom of the sponge with the
bottom of the top cover, affix the sponge in
the center of the cover.
Figure 1-3-25
4. Fix two grounding plate B with the M4 x 8
tap tight S screw to the front/back hooks of
the finisher.
Figure 1-3-26
5. Open the front cover.
6. Remove the screw.
Pull up the connecting lever to lower the
hooks.
Figure 1-3-27
Finisher
Sponge
Hook
Hook
M4 x 8 tap
tight S screws
Grounding
plates B
Hooks
Connecting lever
Screw
To Next Page
Loading...
