2FB/2FC
1-3-17
7. Remove the screw and pull out the connect-
ing rail at the upper part of the finisher.
Figure 1-3-28
8. Cut out the hole covers at two locations on the machine.
9. Position the finisher and machine so the long pin of the connect-
ing plate aligns with the back hole of the finisher, and the two
short pins align with the holes of the connecting rail.
10. Hooking the hooks onto the brackets at the bottom of the
machine, connect the finisher to the machine.
Figure 1-3-29
11. Pressing down on the connecting rail,
secure it with the screw you removed in step
7.
Figure 1-3-30
Connecting rail
Screw
Hole covers
Hooks
Holes of the connecting rail
Connecting plate
Short pins
Long pin
Back hole of the finisher
Connecting rail
Screw
To Next Page
Loading...
