Kyocera TASKalfa 221 - Setting the Fuser Phase Control; Checking the Fuser Temperature; Turning All Leds on

2KJ/2KH
1-3-40
U198
Setting the fuser phase control
Description
Sets the use of fuser phase control to reduce electrical noise generated by the machine.
Purpose
Normally no change is necessary. If electrical noise generated by the machine causes flickering of the lights
around the machine, select fuser phase control to reduces the noise.
Setting
1. Press the start key.
1. Select ON or OFF using the cursor up/down keys.
Initial setting: OFF
2. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U199
Checking the fuser temperature
Description
Displays the fuser temperature, the ambient temperature and the absolute humidity.
Purpose
To check the fuser temperature, the ambient temperature and the absolute humidity.
Method
1. Press the start key. The fuser temperature and ambient temperature are displayed in centigrade (
°C)
and the absolute humidity is displayed in percentage (%).
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U200
Turning all LEDs on
Description
Turns all the LEDs on the operation panel on.
Purpose
To check if all the LEDs on the operation panel light.
Method
1. Press the start key. All the LEDs on the operation panel light.
2. Press the stop/clear key. The LEDs turns off.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
ON Fuser phase control present
OFF Fuser phase control absent
Display Description
FIX TEMP
Fuser temperature (
°C)
SURROUND TEMP
Ambient temperature (
°C)
HUMIDITY Absolute humidity (%)