Default Setting (System Menu)
OPERATION GUIDE 8-5
8
Original/Paper Settings
Register additional types and sizes of originals and paper.
Custom Original Size Setup
Set up frequently-used custom original sizes. The custom size options are displayed on the screen to select
original size. The dimensions available are as follows.
The table below lists the sizes that can be registered.
Up to four custom original sizes can be added. Use the procedure below to set a custom original size.
1 Press the System Menu key.
2 Press [Common Settings], [Next] of Original /
Paper Settings and then [Next] of Custom Original
Size.
3 Press [Change] of any one of Custom 1 to Custom
4, on which you wish to register the size.
4 Press [On], and then press [+],[–] or numeric keys
to enter X(horizontal) and Y (vertical) dimensions.
5 Press [OK].
6 Move to the copy, send, or document box screen
and press the Reset key.
Input units Dimensions
Inch models X: 2 to 17" (in 0.01" increments)
Y: 2 to 11.69" (in 0.01" increments)
Metric models X: 50 to 432 mm (in 1 mm increments)
Y: 50 to 297 mm (in 1 mm increments)
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
