Default Setting (System Menu)
OPERATION GUIDE 8-11
8
6 Press [Close].
The previous screen reappears.
7 To change the duplex printing settings for Custom
1 (-8), press [Next] of Custom 1(-8) and then
[Change] of Duplex. Select [Prohibit] or [Permit]
and press [OK].
The previous screen reappears.
8 Press [Close].
9 To change the name for Custom 1(-8), press [Next]
of Custom 1(-8) and then [Change] of Name. Enter
the name and press [OK].
NOTE: Refer to the Character Entry Method on
Appendix-7 for details on entering characters.
Default Paper Source
Select the default paper source from Cassette 1-4 and Multi Purpose Tray.
NOTE: [Cassette 3] and [Cassette 4] are displayed when the optional side feeder installed.
Use the procedure below to select the default paper source.
1 Press the System Menu key.
2 Press [Common Settings], [Next] of Original /
Paper Settings and then [Change] of Default Paper
Source.
3 Select a paper cassette for the default setting.
4 Press [OK].
5 Move to the copy or document box screen and
press the Reset key.
Automatic Detection of Originals (Available for metric models only)
Automatically detect originals of special or non-standard size.
The table below lists the special or non-standard original sizes.
Item Description
A6/Hagaki As A6 and Hagaki are similar in size, select
either one of them for automatic detection.
Folio Select Folio for automatic detection.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
