2LK/2LN/2LM/2LC
1-2-1
1-2 Installatio n
1-2-1 Installation environment
1. Temperature: 10 to 32.5Ā°C/50 to 90.5Ā°F
2. Humidity: 15 to 80% RH
3. Power supply: 120 V AC, 12.0 A
220 - 240 V AC, 7.2 A
4. Power source frequency: 50 Hz Ā± 2%/60 Hz Ā± 2%
5. Installation location
Avoid direct sunlight or bright lighting. Ensure that the photoconductor will not be exposed to direct sun-
light or other strong light when removing paper jams.
Avoid locations subject to high temperature and high humidity or low temperature and low humidity; an
abrupt change in the environmental temperature; and cool or hot, direct air.
Avoid places subject to dust and vibrations.
Choose a surface capable of supporting the weight of the machine.
Place the machine on a level surface (maximum allowance inclination: 1Ā°).
Avoid air-borne substances that may adversely affect the machine or degrade the photoconductor, such
as mercury, acidic of alkaline vapors, inorganic gasses, NOx, SOx gases and chlorine-based organic sol-
vents.
Select a well-ventilated location.
6. Allow sufficient access for proper operation and maintenance of the machine.
Machine front : 100 cm/39 3/8"
Machine rear : 10 cm/ 3 15/16"
Machine right : 35 cm/13 3/4"
Machine left : 30 cm/11 13/16"
Machine top : 40 cm/15 3/4"
Figure 1-2-1
30cm/11 13/16" 35cm/13 3/4"
Top 40cm/15 3/4"
10cm/3 15/16"
100cm/39 3/8"
To Next Page
Loading...
