2LK/2LN/2LM/2LC
1-4-99
(14) Offset occurs.
(15) Part of image is missing.
(16) Fusing is loose.
Print example Causes Check procedures/corrective measures
Deformed or worn cleaning
blade in the drum unit.
Replace the drum unit (see page 1-5-36).
Defective transfer belt clean-
ing.
Replace the transfer belt unit (see page 1-5-41).
Defective fuser unit. Replace the fuser unit (see page 1-5-45).
Wrong types of paper. Check if the paper meets specifications. Replace paper.
Print example Causes Check procedures/corrective measures
Paper damp. Check the paper storage conditions.
Paper creased. Replace the paper.
Drum condensation. Perform the drum refresh.
Dirty or flawed drum. Perform the drum refresh.
Flawed drum. Replace the drum unit (see page 1-5-36).
Dirty transfer belt. Clean the transfer belt. Replace the transfer belt unit if it is
extremely dirty (see page 1-5-41).
Dirty transfer roller. Clean the transfer roller. Replace the transfer roller if it is
extremely dirty (see page 1-5-43).
Dirt on the back surface of the
contact glass and scanner
mirror.
Clean the contact glass and scanner mirror.
Print example Causes Check procedures/corrective measures
Wrong types of paper. Check if the paper meets specifications, replace paper.
Flawed heat roller or press
roller.
Replace the fuser unit (see page 1-5-45).
Defective pressure springs.
Defective fuser IH.
To Next Page
Loading...
