Kyocera TASKalfa 5550ci - (2) Detaching and refitting the forwarding pulley, paper feed pulley and separation pulley. [30 ppm model; 35 ppm model]

2LK/2LN/2LM/2LC
1-5-7
Figure 1-5-8
(2) Detaching and refitting the forwarding pulley, paper feed pulley and separation
pulley. [30 ppm model / 35 ppm model]
Procedure
1. Remove the primary paper feed unit
(see page 1-5-3).
Detaching the forwarding pulley and paper
feed pulley
2. Remove four stop rings.
Figure 1-5-9
3. Slide the paper feed pulley shaft.
4. Remove the joint and three bushes.
5. Remove the spring and forwarding pul-
ley holder assembly.
Stop ring
Primary paper
feed unit
Stop rings
Stop ring
Joint
Bush
Paper feed pulley shaft
Bush
Bush
Spring
Forwarding pulley
holder assembly