How to correct the hour on my La Crosse Technology Weather Station?
If the hour is incorrect but the minute and date are correct, ensure that the correct time zone and daylight saving time settings are selected.
What to do if my La Crosse Technology WS-9016TWC isn't receiving the WWVB time signal?
If your weather station isn't receiving the WWVB time signal, here are a few things to try: 1. Wait overnight for the signal to be acquired. 2. Ensure the indoor weather station is at least 6 feet away from electrical devices like TVs, computers, or other radio-controlled clocks. 3. Remove the batteries for five minutes, reinsert them, and leave the unit alone overnight without pressing any buttons. 4. If problems persist, contact La Crosse Technology.
Why does my La Crosse Technology Weather Station display "- -" for remote humidity?
The remote humidity might display "- -" because: 1. A temperature-only sensor is being used and displayed. 2. The humidity is outside the range of 19-95%.
Why is no remote temperature displayed on my La Crosse Technology Weather Station?
If no remote temperature is displayed, try these steps: 1. Remove all batteries, reinsert into the remote sensors first, then into the indoor weather station. 2. Place the remote sensors closer to the indoor weather station. 3. Ensure all batteries are fresh.
How to fix faint LCD on La Crosse Technology Weather Station?
If the LCD is faint, try the following: 1. Set the LCD contrast to a higher number. 2. Replace the batteries.
Instructions for installing batteries in both the remote temperature sensor and the main indoor weather station unit.
Steps to manually set the time if the WWVB radio signal is unavailable.
Steps to manually set the date, month, and year.
Steps to set the device alarm time, including hour and minute adjustments.
Information regarding the display of outdoor temperature, including max/min readings and transmitter identification.
Solutions for issues related to the device not receiving the WWVB time signal.
Solutions for when the hour is incorrect but the minute and date are displayed correctly.
Troubleshooting steps for a dim or faint LCD screen.
Solutions for when the outdoor temperature is not shown on the display.
Troubleshooting steps for when the humidity reading displays '- -'.
General| Display Type | LCD |
|---|---|
| Indoor Temperature Range | 32°F to 122°F (0°C to 50°C) |
| Outdoor Temperature Range | -40°F to 140°F (-40°C to 60°C) |
| Indoor Humidity Range | 20% to 95% |
| Wireless Range | 330 ft (100 m) |
| Power (Display) | 3 x AA batteries |
| Power (Outdoor Sensor) | 2 x AA batteries (not included) |
| Time Display | 12/24 hour format |
To Next Page