Note: When 24h mode display is selected, the calendar format will be date and month
display. When 12h mode display is selected, the calendar format will be month and
date display.
MANUAL TIME SETTING
In case the Weather Clock is not able to detect the DCF-signal (disturbances, transmitting
distance, etc.), the time can be manually set. The clock will then work as a normal Quartz
clock.
To set the clock :
1. The hour and minute digits start flashing in the time display section.
2. Use the CH/ + key to adjust the hours and then press SET key to go to the minute
setting.
3. The minute will be flashing. Press the CH/ + key to just the minutes.
4. Confirm with the SET key and enter the “Calendar Setting” or exit the setting mode
by pressing the SNOOZE/ SUN key
Minutes (flashing)
To Next Page
Loading...
Need help?
General
