Mascot FT, Heating Only, Boiler
Page 1
Item Description Qty
LAARS Wall Mounted,
Boiler
MFTHW (all sizes)
1
Installation Instructions and
User’s Manual
1
Condensate Hose
1
Wall Mount Bracket
1
2 types of Wall Anchors
4
Pressure Relief Valve
(CH LINE 3/4
˝
30psi)
Model: CASH ACME F-82
1
Mesh Screens
3”
2
SECTION 1
Product Accessories
1.1 Introduction
This manual provides information necessary for the
installation, operation, and maintenance of the LAARS
Heating Systems Mascot FT Boiler. All application
and installation procedures must be read and reviewed
completely before proceeding with the installation. Consult
the LAARS Heating Systems factory, or your local factory
representative, with any problems or questions regarding
this equipment. Experience has shown that most operating
problems are caused by improper installation.
All installations must be made in accordance with
1) American National Standard Z223.1/NFPA54-Latest
Edition “National Fuel Gas Code” or
2) CSA B149.1 “Natural Gas and Propane Installation Code” and
with the requirement of the local utility or other authorities having
jurisdiction. Such applicable requirements take precedence over
the general instructions contained herein.
All electrical wiring is to be done in accordance with the local
codes, or in the absence of local codes, with: 1) The National
Electrical Code ANSI/NFPA No. 70-latest Edition, or 2) CSA
STD. C22.1 “Canadian Electrical Code - Part 1”. This appliance
must be electrically grounded in accordance with these codes.
1.2 Included with the Appliance
4
To Next Page
Loading...
