MECHANICAL SECTION page 4
1.0 ACTUATOR COMPONENTS “ 5
2.0 ARMS “ 5
3.0 GENERAL SAFETY RECOMMENDATIONS “ 6
4.0 MACHINE DIRECTIVES “ 6
5.0 INSTRUCTIONS FOR USE “ 6
6.0 HOW TO PREPARE AND FIX THE ACTUATOR “ 7
7.0 TECHNICAL DRAWINGS “ 8
8.0 ARM CONNECTIONS “ 10
9.0 ARM REMOVAL “ 11
10.0 EXTENSION SHAFT “ 12
ELECTRONIC SECTION page 15
1) ELECTRICAL CONNECTIONS “ 16
2) DESCRIPTION OF LOGIC PART LGN OF THE CONTROL UNIT “ 18
3) HOW TO RESET THE SPRING PRELOAD “ 19
4) HOW TO SET THE DEVICE AT WORK (INITIAL SET-UP) “ 20
4.1) HOW TO CANCEL A PREVIOUS INITIAL SET-UP “ 20
5) MANUAL FUNCTION SELECTORS “ 21
5.1) FUNCTION SELECTOR SWITCH “ 21
5.2) MANUAL SELECTOR “ 21
5.2.1) ELECTRICAL CONNECTIONS “ 21
5.2.2) OPERATING MODES “ 21
6) FUNCTIONS OF DIP SWITCH S1 “ 22
7) FUNCTIONS OF DIP SWITCH S2 (only via digital selector) “ 23
8) POTENTIOMETER ADJUSTMENTS “ 24
9) DIGITAL SELECTOR “ 25
9.1) THE REMOTE CONTROL “ 26
9.2) ADJUSTING THE DEVICE WITH REMOTE PROGRAMMING VIA SELECTOR “ 27
10) COURTESY MODE FOR THE DISABLED “ 28
11) ELECTRO-LOCK RELEASE WITH FREE DOOR “ 28
12) PHOTOCELL BOARD “ 28
13) SWING DOOR WITH TWO WINGS “ 30
13.1) ELECTRICAL CONNECTIONS “ 30
13.1.1) ACTUATOR WITH MASTER CONTROL UNIT “ 31
13.1.2) ACTUATOR WITH SLAVE CONTROL UNIT “ 31
13.2) HOW TO INSTALL THE DEVICE “ 31
13.3) FUNCTIONS AND ADJUSTMENTS “ 32
13.3.1)HOW TO ADJUST THE MASTER ACTUATOR “ 32
13.3.2)HOW TO ADJUST THE SLAVE ACTUATOR “ 32
13.3.3) HOW TO CHECK THE WAY THE DOOR OPERATES “ 32
14) PEDESTRIAN OPENING “ 33
15) LIST OF PARAMETERS TO SELECT FOR THE CONTROL UNITS “ 33
16) MEANINGS OF THE BUZZER SIGNALS (BEEPS) “ 34
17) TECHNICAL SPECIFICATIONS “ 34
18) ADVANCED FUNCTIONS - TECHNICAL MENU “ 35
CONTENTS
3
To Next Page
