All equipment used should be of a suitable quality and should be calibrated where deemed
necessary in compliance with EN 12469.
10.6 Test information
For more detailed information on the individual tests please refer to the factory test report delivered
with the cabinet.
During installation and service testing, the values measured during the factory test are the target
values to be reached as close as possible.
From the factory all parameters and functions has been set to ensure that all requirements are meet
and that the cabinet will protect the samples handled, the operator doing the work and the
environment in the surrounding room.
All tests should be done by authorized test technician approved by LaboGene.
11 Options for Fortuna cabinets
A number of optional components can be fitted to the Fortuna cabinets.
The cabinets can be ordered with these options or the options can be retro-fitted by trained service
technicians.
The most common options are listed below. Contact your distributor or LaboGene for availability of
other options.
11.1 LED light
As an option to the traditional fluorescent light tubes, LED light can be fitted. Two versions exists a
non-dimmable and a dimmable.
The use of LED light will save on energy but will still give a good working light with approximately
the same intensity as the traditional fluorescent light tubes. The LED light requires installation of a
special ballast.
To Next Page
Loading...
Need help?
General
