LaboGene ScanSpeed 1248 - Setting Centrifugation Time; Acceleration and Deceleration Control

07052013RS01
Cat. No. 9.900.900.758
CopyRight © 2013
Page 15 of 20
4-3. Setting Time
▶ Speed setting unit: 1min. or 10 min./ 1 sec. or 10 sec.
Action
 Time is down-counted after starting centrifugation.
1. Touch the [TIME] button once.
 ‘MIN’ on LED is flickering.
2. Touch the [
▲▼] buttons to change input value.
 After keeping holding finger on the [
▲▼
] buttons for 5
seconds, the unit of setting value is changed to 10min.
from 1 min.
 If you do not touch the [
▲▼
] button for 5 seconds, the
setting mode is cleared.
3. Touch the [Enter] button to pass ‘SEC’ value setting.
4. Touch the [
▲▼
] buttons to change input value.
 After keeping holding finger on the [
▲▼] buttons
for 5 seconds, the unit of setting value is changed
to 10 sec from 1 sec.
 If you do not touch the [▲▼] button for 5 seconds, the setting
mode is cleared.
5. Touch the [Enter] button to complete the setting.
4-4. Acceleration / Deceleration
Use the adjustment function of acceleration & deceleration levels to protect sensitive samples.
Action
1. Touch [ACC/DEC] button.
2. Touch the [▲▼] buttons to change input ACC value.
 ACC blinks on the ACC/DEC display.
 Input the desired level of ACC from 1 to 9. (Level 9: The
fastest acceleration)
 If you do not touch the [▲▼] button for 5 seconds, the
setting mode is cleared.
3. Fix the ACC level by touching [Enter] button.
4. Touch the [▲▼] buttons to change input DEC value.
 DEC blinks on the ACC/DEC display.
 Input the desired level of DEC from 0 to 9. (Level 0: Natural
deceleration / Level 9: The fastest deceleration)
 If you do not touch the [▲▼] button for 5 seconds, the
setting mode is cleared.
5. Fix the DEC level by touching [Enter] button.