LaboGene ScanSpeed 1248 - Program Saving and Recalling

07052013RS01
Cat. No. 9.900.900.758
CopyRight © 2013
Page 16 of 20
4-5. Program Saving & Recalling
Action
4-5-1. Saving
1. Set parameters. (Refer to 4-2 ~ 4-4 )
2. Touch the [PROG] button longer than 3 seconds.
 Check the message of “PROGRAM SAVE: ##” on the
display window.
3.
Touch the [▲▼] buttons to change input Program number.
 If you do not touch the [▲▼] button for 5 seconds, the
setting mode is cleared.
 Save up to 100 programs. (Program numbers from 00 to
99)
4. Touch the [Enter] button to complete the saving.
4-5-2. Recalling
1. To recall the saved program, just touch the [PROG] button shortly
(less than 1 sec.).
 Check the message of “PROGRAM CALL: ##”, on the
display window.
2. Touch the [▲▼] buttons to select program number you want to
recall and then touch the [Enter] button.
 If you do not touch the [▲▼] button for 5 seconds, the
setting mode is cleared.
 When you touch the [Enter] button, display window show the
saved setting parameters (RPM/RCF, TIME, TEMP).